how do you tuck the diving boards?
-
8Tuck the diving boards and buy a valence37.50%3Buy plastic bumpers (Front and Rear) and front valence62.50%5The poll is expired.
-
brickwall -
brickwall?Comment
-
Drill the shocks. Just watch the your face, cause the oil will get you good. Then after the oil drains just push them in to where you want then to sit.
1992 BMW 325iC
1978 Chevrolet Monte Carlo1965 Chevrolet Corvair Monza 140hpComment
-
where would i need to drill the shocks at?Comment
-
On the bigger outer tube, not the smaller tube that goes into the bigger one. It may be hard to push them in after you drill the shocks, so you may have to kick them or use a brick wall to push them in.
1992 BMW 325iC
1978 Chevrolet Monte Carlo1965 Chevrolet Corvair Monza 140hpComment
-
so once i drill them i can push them in an they'll sit where i put them?Comment
-
99% of the time they will. My front bumper would move out alittle bit once and awhile, before i put the euro bumper on. But the back bumper hasn't moved since i did it over a year ago.
1992 BMW 325iC
1978 Chevrolet Monte Carlo1965 Chevrolet Corvair Monza 140hpComment
-
vote on my poll budsComment
-
is this for your 1991 325iC, and it has diving boards? Anyway, I voted for getting plastic bumpers..Comment
-
get plastics for sure if you have a cabby.Comment
-
yep, well the production date of the "IC" was 8/1990 ment for the 91 model year, i guess.Last edited by Bimmerboy91; 03-31-2007, 07:56 PM.Comment
-
c'mon vote in my poll. your vote counts;)Comment
Comment