mounting hardware for side moldings

[xLibelle]

So i pulled this car appart telling myself i'll remember how to put it back together.
....thats never the case :sad:

so, its a late model 2-door. RealOEM shows 11 and 7 as being the two gromets used. I have some number 11's but not enough and was still confused as to what i need. (i'm only concerned about the gromets that the nippels push into)

anyone have theirs appart or this info noted down somewhere?

[Disaster Inc]

Not sure what your trying to figure, 11 are the grommet(s) for the fenders. The rear of the door moldings and the 1/4 moldings have the cap nuts. I believe 7 sits on pin as it passes thru panel then cap nutted.

Chris

[ddavidv]

Yep, 11's are all you need for the ones that actually have pins (fenders, IIRC). Don't break the pins off the moldings because you can't buy those seperately.

[xLibelle]

chris, i had to state late model because you just described early model.

david... i already had to buy another peice because i didnt watch a step and broke one off

thx for the info, i was going to get the others as the same, but i remember when i was taking them off, that there were two different gromets. I dont think it matters anyway, i just wanted to feel better by asking.