Question for the Z4 shifter guys

[Mystikal]

I installed my Z4 3.0 rod on Monday, easily the best bang for buck mod on these cars. :D

But, now that the shift knob is SO MUCH lower, there is a lot of excess material in the shift boot, it is all bunched up and ugly now. What can I say, I'm a perfectionist. I'm due for a new boot anyways, has anyone found a good solution? My first instinct would be a boot from a Z-car, but they are of different shape. I just want something that looks OE again, has anyone accomplished this?

[graphik]

i cut mine some and folded the excess material at the top (near the shift knob) back inside of the shift boot. if that makes any sense...

[Schnell 318]

i have a momo boot, which was roo short when i had the stock lever, but now it fits perfect. i would just cut material off the top and then roll the cut edge in

[Rob]

my boot looks fine, maybe the 'skirt' (the part that goes over the shift lever) on my RK3 is shorter?