If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Just incase I put the wong part down, its the black strips on the doors in your sig
Those are door moulding strips, and yes, those can be removed.
They are just held in by little white expanding clips. Get one end up, and GENTLY pry up the moulding. Each of the clips are going to break, and you will have to replace them.
Just incase I put the wong part down, its the black strips on the doors in your sig
Those are door moulding strips, and yes, those can be removed.
They are just held in by little white expanding clips. Get one end up, and GENTLY pry up the moulding. Each of the clips are going to break, and you will have to replace them.
The moulding clips? They wont break all the time, theres a screw in the front of the door to undo first.
Thanks, Should I buy some extra clips from the dealer before I take them off? Does anyone have the part number.
I want to take them off So I can clean them plus there is a bunch of white power from when I polished the car a while back thats all around the permimiter, make the car look like shit.
were is this screw I gota take off? Is it behind the door panels on the inside of the car?
Comment