black headliner piece

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Fingprep
    Noobie
    • Nov 2008
    • 27

    #1

    black headliner piece

    Hey can some one tell me how to take the black headliner piece off with out breaking or bending it?
    sigpic
  • Jean
    Moderator
    • Aug 2006
    • 18228

    #2
    The one near the front windshield, above the sun visors? It's tucked under the left/right door seals and sunroof part...
    Mtech1 v8 build thread - https://www.r3vlimited.com/board/sho...d.php?t=413205



    OEM v8 manual chip or dme - https://www.r3vlimited.com/board/sho....php?p=4938827

    Comment

    • Fingprep
      Noobie
      • Nov 2008
      • 27

      #3
      That's the one. Do you have to take the sunroof out to remove it? Is there any clips I should worry about breaking?
      sigpic

      Comment

      • Jean
        Moderator
        • Aug 2006
        • 18228

        #4
        Just slide it back, you'll just need to remove 6-10 small phillips screws. Remove the sunvisors and brackets, and pull the top sections of front door seals down. And sunroof crank if it's manual.
        Mtech1 v8 build thread - https://www.r3vlimited.com/board/sho...d.php?t=413205



        OEM v8 manual chip or dme - https://www.r3vlimited.com/board/sho....php?p=4938827

        Comment

        • Fingprep
          Noobie
          • Nov 2008
          • 27

          #5
          How do you get to the screws that are holding the back of the headliner piece? I have the sunroof open and can see the screws but can't get to them my off set screw driver is too long. Are you suposed to take the wind deflector off? If so how do you get that off?
          sigpic

          Comment

          • Van Westervelt
            R3V OG
            • May 2006
            • 9365

            #6
            Yes, you have to take the wind deflector off. It unscrews all along on the underside after you snap each side out of its lifter arm.
            sigpic

            Comment

            • Fingprep
              Noobie
              • Nov 2008
              • 27

              #7
              How do you get the lifter arms off?
              sigpic

              Comment

              • Fingprep
                Noobie
                • Nov 2008
                • 27

                #8
                never mind
                sigpic

                Comment

                Working...