So while removing my driver side seat to make it easier to work on the pedals for my 5 speed swap, i noticed i have a set of wires coming from the floor board, that plug into wires on the bottom of my seat. I'm assuming this is for heated seats (if not, what then?). However i don't have any switches of the sort in my car. Is there a way to retrofit it?
-
-
Airbag sensor, I think.
[THE 501 club - Founding Member] -
Really? Thats pretty neat then :DComment
-
I thought it was the seat belt light thingy, probably wrong.
Comment
-
ding ding ding
if you follow the wires some go to the seatbelt, sounds the gong when undone i believe.
i guess some might be for some kind of airbag sensor, dont know why itd be in the seat though.Your signature picture has been removed since it contained the Photobucket "upgrade your account" image.
Originally posted by TimKninjaComment
-
As did I. I have it in my 84 (read: no airbag).Originally posted by permitOriginally posted by GrueliusComment
-
Im positive it is. Disconnect it and find out.Comment
-
you know, it could be the seat belt thingy? ;)
[THE 501 club - Founding Member]Comment
-
Word. Dunno what i was thinking, pretty dumb to assume its for heated seats when only one side had it, and the console had no cutouts for the switches.Comment
-
its the seatbelt thingy. Its unplugged in mine, and my SRS ligh blinks in my overhead checkpanel. srs = Saftey Restaint System (seatbelt)
Comment
-
Retro is a carpet up job, and alot of work on the seats.
Here is a pic of the loom that goes inside the seat.
Andrew
Andrew AT E30zone.co.uk | H23-is | S14Comment
-
how much did that cost you?Comment
-
they are £50 each.
but i swaped a M3 leather interior for a set of leathers with these ellements in them.
So it cost me nothing.
Andrew
Andrew AT E30zone.co.uk | H23-is | S14Comment
Comment