Roll bar install question...

[bwh13]

I'm picking up the Autopower roll bar tomorrow and will install next wekend. Anyone installed one of these and any tips?

[Van Westervelt]

I installed one last summer. Mark all holes, and drop in the bolts at each one before you drill the next hole. Bolt-in? Going into a 2/4 door? Which bar with what options? Running harnesses?

Get Padding!

I got the race bar with bolt out cross bars.
PM me if you have any other q's

[MR 325]

I had an Autopower street roll bar in my old car. Install was very simple and straight forward. Watch out for the fuel/brake lines on the driver side and thats about it.

[Van Westervelt]

I had an Autopower street roll bar in my old car. Install was very simple and straight forward. Watch out for the fuel/brake lines on the driver side and thats about it.

x2 forgot about that. be sure not to drill through them! :)

[bwh13]

It's the street bar with the harness bar. My Schroth harness is actually attached to the rear seat belt anchor points so I don't have to worry about them. Thanks for the tips on the fuel lines...where's best place to buy padding?

[Dave]

summit racing is decent. Get the SFI rated dense stuff - save the pool noodle looking stuff for the odd spots where you cant get the SFI to go.

[Van Westervelt]

summit racing is decent. Get the SFI rated dense stuff - save the pool noodle looking stuff for the odd spots where you cant get the SFI to go.

x2. I got mine from the same guys I ordered the bar through. safedrives.com or somethin