US Ellipsoids Installed; Lighting Issues

[ZJP]

When the low beams are on and I flick my high beams, both low beams turn off and only my driver side high beam turns on.

Any ideas as to why this is happening?

[atomic]

Unless you have done the relay jumper, then that is normal with how US lipsoids work and only one high beam is likely because the nonworking one has a blown bulb...

[ZJP]

Oh I see. I was under the impression that the high beams would light up along with the low beams. I never heard of one without the other.

[IRON-E]

unless you have done the relay jumper, then that is normal with how us lipsoids work and only one high beam is likely because the nonworking one has a blown bulb...

+1 ;)

[coolasacuc]

totally normal except you have a high beam out