Hey guys,
So I'm working on installing a set of headlight washers onto a pair of Hella Euro Smileys. I came across a problem...
The shaft for the wipers does not fit through the hole on the headlight:
Not only that but the bracket that holds the wiper motor in place does not line up.
The only guide that I could find for the install no longer has pics so its difficult for me to reference to anything.
Did anyone encounter this when installing their wiper system? I have a feeling that its the fact that they're Hella units vs Bosch units (the wiper motors are Bosch units).
What say you R3V? Should I just drill the holes out and make it work? I'm not crazy about drilling but if thats the solution then so be it.
So I'm working on installing a set of headlight washers onto a pair of Hella Euro Smileys. I came across a problem...
The shaft for the wipers does not fit through the hole on the headlight:
Not only that but the bracket that holds the wiper motor in place does not line up.
The only guide that I could find for the install no longer has pics so its difficult for me to reference to anything.
Did anyone encounter this when installing their wiper system? I have a feeling that its the fact that they're Hella units vs Bosch units (the wiper motors are Bosch units).
What say you R3V? Should I just drill the holes out and make it work? I'm not crazy about drilling but if thats the solution then so be it.
Comment