DIY smoked ?s

[Mless5]

1. What do you use to make holes in the reflector?
2. How do you find centers?
3. What kind of glue is strong enough for the cross to reflector glueing?
4. How thin could the metal for crosses be? I have a sheet of 22ga steel and some thing flashing. OR maybe there is some kind of plastic that won't melt? Which one should I use?

[mikeedler]

I could tell you, but then I would have to kill you. figure it out, its not that difficult. I paid alot of money to buy an original set, tear it apart, and then have the parts made to make other sets.

[BDSax]

thats because you have balls. and you do good work. i love mine. i straightened out my problem. thanks mike!

[straight6pwr]

ive got a question regarding just stripping down the headlights. how do you remove the projector assembly from the housing? on the back there are the 3 screws but the heads are the ones that can only be tightened, not unscrewed.

[mikeedler]

every set I have ever had, which is in the hundreds, has all had regular phillips screws in them.

[straight6pwr]

every set I have ever had, which is in the hundreds, has all had regular phillips screws in them.

damn, the u.s. ones have those stupid ones.

[mikeedler]

I also have had a set of u.S. ones, and they had reg. screws too.
just use a small vise grip, it is screwed into plastic, should'nt be hard to get it unscrewed.

[straight6pwr]

I also have had a set of u.S. ones, and they had reg. screws too.
just use a small vise grip, it is screwed into plastic, should'nt be hard to get it unscrewed.

yeah, turns out they arent in very tight so i just used a needle nose. im now two highbeams away from completion. woot.