Help w/ HID's and Euro Smiley's

[Low Level E30]

Ok, so if I have US Ellipsoids already, I can throw A + B + E away.

Then plug the car's harness into 3, and the rest is simple.

Is that all correct?

[Low Level E30]

I'm now thoroughly confused. Too many edits.

Can you spell this out in a most basic fashion :D ?

[E30 Reaktionär]

It looks like e goes to 3 and d to 2 and c to 1. A is hot and B is ground, and they go to your factory harness.

[Low Level E30]

So I can pull A / B / E out and throw 'em away?

Then the factory connector plugs into 3?

Is that it? So easy??! :D

[backtrail69]

You discard e if you use the factory connector. 3 is the pos/neg in and 1/2 is pos/neg out to the bulb. Its pretty simple.

[Low Level E30]

A and B just connect to the pos and neg of the headlight connection. The rest just plugs in. You can only plug them into one place.

But E does not plug into 3, does it... ?

I'm assuming the car's wiring harness plug goes into the ballast at 3.

So where does E connect?

Thanks!

[backtrail69]

A and B just connect to the pos and neg of the headlight connection. The rest just plugs in. You can only plug them into one place. You can also plug your 9006 connector directly into number 3 if you have us ellips.

[Low Level E30]

Hey guys,

Need some help!

I'm not sure how to put these parts together yet - I have a rough idea, but I need some clarification. Here's a diagram I made - these are the only parts I have:



Connections (please correct me if I'm wrong):

- A + B connect to the wires in the Euro ellipsoid cap (red is the ground)

- C + D connect to 1 + 2

Here's where I'm confused!

- Does 3 connect to the car's wiring harness (the plug that normally goes into the back of the US ellipsoid) ?

- Where does E connect?