elipsoid swap

[colombacho]

I have been looking and searching all over the lighting section and cant figure it out. And i am not sure what i am doing. already burned more than seven fused connecting everything to everyting with no luck.

My sealed beams have three connections
pass side:
1 Ground= brown
2 current= white/blue
3 misterious 3rd wire that has no current runing through= yellow/white

Drivers side:
1 Ground = brown
2 current = white/purple
3 same stupid third wire tha f's up everyting=yellow/white


Elipsoids with two connections(9006 i think)
left and right
1 Ground
2 current


the big problem i have is that my low beams do not turn on. only when i turn my highs they turn on. I also checked for current and there is current but the light does not turn on.

Am i supposed to do something with this EFFING! THIRD CABLE!!:curse:

Any help appreciated:D

[JasonC]

Thumb though this thread, http://www.r3vlimited.com/board/showthread.php?t=59735 You shouild find what you're looking for.

[colombacho]

Mmmm, it better not be that simple.

I'll try it tonight.

[golde30]

yah, you are using the wrong wire for + on the low beams.

[colombacho]

thanks alot guys, the other wire was not working because i had already blown the fuse. Got it good now. just a tipical @sshole mistake.

[Boomerang]

thanks guys, i was going to make a topic until i came across this one, very informative.