how did you guys cut your crosshairs?

[scobaru]

I have a sheet of metal that I'm going to cut for crosshairs.... what would be the best method to do this?

[Jordan]

If you use thin steel or aluminum... sharp stainless scissors will work fine. If its thicker steel... then tin snips.

[Van Westervelt]

dremel too or a die grinder works. depends on how steady of a hand you have tho. lol

[scobaru]

you use the rotating cutting wheel for a dremal? I'm using some semi thick aluminum

[e30pwr]

Numbers?

[GaryE30]

Tin snips then get the intricate stuff with the dremel.

[Sean5294]

the dremel is king, just watch out for the cutting wheel breaking and hitting you in the face!

[turbogeek]

assuming you already have the stencil pattern yes?