finally got around to pulling my blower motor switch. Looks to be fine in all settings. Also checked to see if i was getting power to the switch. It appears that its either my blower or resistor(im hoping its this).
after getting the whole thing apart, i decided to check the rear defrost switch. Im getting power through the plug through one pair of contacts in the plug(i got power through two pairs of contacts in the hazard light plug). I need to figure out which contacts to check on the actual switch to check for resistance? I touched all of them with the multimeter in every combo i could. I only got a no resistance through on pair of contacts. I tried the hazard switch and got no resistance through two pairs of contacts?
after getting the whole thing apart, i decided to check the rear defrost switch. Im getting power through the plug through one pair of contacts in the plug(i got power through two pairs of contacts in the hazard light plug). I need to figure out which contacts to check on the actual switch to check for resistance? I touched all of them with the multimeter in every combo i could. I only got a no resistance through on pair of contacts. I tried the hazard switch and got no resistance through two pairs of contacts?