head unit wont power up after cutting OBC harness

[der affe]

I removed my euro clock and cut the harness out because I sold them. I cut the harness with both the ground and the positive cables disconnected. I bell capped the wire ends then reconnected the battery cables and now the deck wont power up of the 4 wires that I capped 3 were neg and 1 was constant power.

Does the deck power run through the OBC harness ( or maybe the ground?).

Everything else works and there are no blown fuses.

Guidance is greatly appriciated!

[AndrewBird]

Aftermarket deck or factory? If it is aftermarket, it sounds like who ever installed it tapped into power from the OBC and didn't use the factory wiring.

[der affe]

Aftermarket alpine digital only. It LOOKED like they cut the factory harness and wired it in using the factory wires, maybe not I guess............