NEED HELP. Remote starter/ alarm/ keyless entry / push start

[M3 Cereal]

Hi i just about have everything wired up! following the scarse amount of DIY and threads i can only make it so far. the box has power ive done all the door locks. windows. lights. and power correctly but below its asking for input connections for the start, acc, and key inert not the output

i need to wire these four more wires to finish please help =]

Green: key insertion (+/-) INPUT) ..... connect toward the keybox direction
Blue: ACC(+) INPUT) .... connect toward the keybox
Yellow: Start (+) INPUT) ..... connect toward keybox.
BLK/green (+/-) OUTPUT .... connect toward key insertion (+/-)

---------------------------------------------------------------------------------------

the others i need to wire are (but not completely positive if they are required)

Orange: Parking(+) Detection.... Connect to parking switch after selecting (+/-) polarity ( the problem is its not a automatic i have a manual)
Red: Parking (-) detection---- above^^^^^

Grey:door(-) detection..... connect to door unlock- integration board

skyblue: terminal (+) connect to the L terminal wire of the generator

Purple: Warming-Up detection ..... Connect to the wire of the warning coil

Big Grey: used for musso, Winstorm (-)250mA output ?????? (WHATS THAT)

Big Brown (+) Trunk output after seeing polarity

---------------------------



HERE IS WIRING DIAGRAM FOR UNIT

http://www.auto-innovatio.com/magento/media//ST800.jpg

[M3 Cereal]

bump. new day and still need this running. where are these wires going to be locayed to can i just plug them in to a 12v source

[M3 Cereal]

bump =/