I had a coil pack die on my ms2 wasted spark thursday, so #1 &i #6 were dead holes. I replaced the coil pack and #1 came back, but #6 was still dead.
Next i started ohm checking the wires and #6 had 19.87 ohms so i know that one is bad, but #1 showed 3.08 ohms and the rest were reading in the 2.1 range.
I did some searching on line, but could only find specs for carbon wires.
Does anyone know the acceptable ohm varience for msd wires? Is almost 1 ohm difference ok? I am making a new #6 wire out of some extra wire, but am not sure if i need to replace the #1 also.
Next i started ohm checking the wires and #6 had 19.87 ohms so i know that one is bad, but #1 showed 3.08 ohms and the rest were reading in the 2.1 range.
I did some searching on line, but could only find specs for carbon wires.
Does anyone know the acceptable ohm varience for msd wires? Is almost 1 ohm difference ok? I am making a new #6 wire out of some extra wire, but am not sure if i need to replace the #1 also.