88 325ix no fader
pioneer deh 9300bt hu
2 Infinity 475a amps
2 infinity 61/2" 62.9i coax rear 2ohm
2 infinity 51/4" 5030c components 2ohm front
1 kicker SB L5 10" sub 4 ohm trunk
the cab speakers are going to 1 amp. the sub is going to the other. sub wired in series @ 4ohms bridged. I realize its not the correct amp to use for the sub, but got a package deal.
4awg power to a dist. block then 8awg to the amps.
8awg grounds to the paint free stud that the battery ground connects to.
All new 16awg to the cab seakers and 12awg to the sub.
3 sets of rca's to the amps.
I am getting crazy interference through the speakers when the car is running. With the key set to acc. it sounds amazing. the whining increases with rpms.
heres the kicker, whining goes away when i unplug front or rear rca AND touch it to a bare spot (door hinge).
The only thing i can think of is....i ran ALL the wires on the passenger side too close to the 12v supply. Or theres a break in an rca wire.
i tried moving the grounds...no change.
do you think its a ground problem in the engine bay?
Any thoughts??
thanks!
pioneer deh 9300bt hu
2 Infinity 475a amps
2 infinity 61/2" 62.9i coax rear 2ohm
2 infinity 51/4" 5030c components 2ohm front
1 kicker SB L5 10" sub 4 ohm trunk
the cab speakers are going to 1 amp. the sub is going to the other. sub wired in series @ 4ohms bridged. I realize its not the correct amp to use for the sub, but got a package deal.
4awg power to a dist. block then 8awg to the amps.
8awg grounds to the paint free stud that the battery ground connects to.
All new 16awg to the cab seakers and 12awg to the sub.
3 sets of rca's to the amps.
I am getting crazy interference through the speakers when the car is running. With the key set to acc. it sounds amazing. the whining increases with rpms.
heres the kicker, whining goes away when i unplug front or rear rca AND touch it to a bare spot (door hinge).
The only thing i can think of is....i ran ALL the wires on the passenger side too close to the 12v supply. Or theres a break in an rca wire.
i tried moving the grounds...no change.
do you think its a ground problem in the engine bay?
Any thoughts??
thanks!
Comment