Custom Interior Wire Harness

[JFarhanbod]

So my e24s interior harness had been fucked with over the years leaving some stuff not working. I decided to rip it all out and start from scratch. My primary goal is getting the car running then I can worry about everything else later. Heres where I'm stuck.

all i should need is ignition, starting, and charging.. which are located in the c101



problem is theres a bunch of ignitions in the c101. if i hook up pins 1,11,12,14, and 19, I should have a running car correct?

[01rs25]

Custom Interior Wire Harness

Buy a new un-molested harness and use that. If you are asking these questions this early. You're already well over your head.


Goodluck!

[JFarhanbod]

Not an option. It doesn't seem too hard, I just want some solid opinion from someone experienced before I blow shit up. I'm using an ezwiring kit (similar to painless) so it's just a matter of running the wires to everything

[JFarhanbod]

Bump

[MyE30]

I'm not familiar with e24s but judging by the picture you provided your reasoning makes sense. If the "TDC sensor" fuses are related to the crank position sensor you may those as well. Also, is the fuel pump reply part of the engine harness?

[JFarhanbod]

anyone know how to wire the tdc sensor?