Announcement

Collapse
No announcement yet.

Help with sub install

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Help with sub install

    Alright, I was wiring up my amp for my JL Audio 12w6 (which I got for free by the way) but have run into a problem. Because I have a vert the battery is in the front, and the problem is that I can't find where to run the power wire for the amp from the battery to the interior, once I get it to the interior I will be set. Any Help?

    #2
    There are holes in the firewall blocked by grommets on the drivers side of the firewall. If you look from inside the car with the lower trim panel on the drivers side taken off, you'll find the punch outs.

    Comment


      #3
      Thanks for the advice, by lower trim panel you do you mean the peice that covers the pedals and stuff?

      Comment


        #4
        Yeah, the piece that covers all the wiring under there above the pedals (with the three 90 degree screws). Should see some stuff over by the clutch if I remember correctly.

        Comment


          #5
          This is what I see, should I cut out the vacant hole?

          Comment


            #6
            yes. Use a sharp, new razor blade as the rubber is hard to cut. Cut the whole smaller then the wire so it will seal up correctly.
            Chris
            90 Corrado/91 M3/01 M5

            Comment


              #7
              thanks, I just got it through.

              Comment


                #8
                I put my wires thru the holes where the a/c lines used to be since the batt. is on that side anyways . what year vert you say you had ROYAL ?
                :pimp:

                Comment

                Working...
                X