I would like other opinions on if I should get a new M30 wiring harness. The PO did something, I believe, to the wiring harness that to me don't look quite right...but I am not too comfortable with my opinion.
I would like to say that the car ran, and seemed to run fine (everthing electrical worked w/ exeption of speedo).
1) Many of the clips like this one are broken like the one pictured. The injector ones had me most concerned but they seemed to look snug and holding on. Should I be concerned about these.
2) Main relays. This is were I can't really trust my own opinion because everything worked. This just looks like a total clusterfuck of wires. Does this look like a fire hazard ect. or are these what the main relays usually look like? (one says main, another says fuel/(something else) and then I'd I have to check on the third one, all on tape.)
Opinions would be appreciated. Thanks
I would like to say that the car ran, and seemed to run fine (everthing electrical worked w/ exeption of speedo).
1) Many of the clips like this one are broken like the one pictured. The injector ones had me most concerned but they seemed to look snug and holding on. Should I be concerned about these.
2) Main relays. This is were I can't really trust my own opinion because everything worked. This just looks like a total clusterfuck of wires. Does this look like a fire hazard ect. or are these what the main relays usually look like? (one says main, another says fuel/(something else) and then I'd I have to check on the third one, all on tape.)
Opinions would be appreciated. Thanks