So I finished my project and all was well. Drove it about 35 miles and the rear main was leaking. So I just got done resealing the rear main and input shaft seal.
Then I fired it up, ran like butter. Shut it off and went to crank 5 minutes later.....POP! No crank, no start, no lights interior and exterior.
I am horribly unskilled at electrical. So where do I start?
Then I fired it up, ran like butter. Shut it off and went to crank 5 minutes later.....POP! No crank, no start, no lights interior and exterior.
I am horribly unskilled at electrical. So where do I start?
Comment