Rear air bag install, Front air bag strut build on a e30.

[Buzz944]

Sorry to revive this old thread but I really really need those pic and they are not opening
Anyone by chance have them or can send them to me?

[280zx2by2]

you need the airlift specific plates for the struts unless you make adapters to fit aftermarket.

After getting the front struts in and taking a few measurements and from messaging Cosmo it looks like you'd need to machine the shoulder of the strut down .650" and die the threads .650" further. Also have to make a .866 length bushing with 14mm OD and 12mm ID (.039 wall) to account for the difference in the camber plate pillow ball and strut shaft.

Would the strut be fine running on the just camber plate like that or would some sort of thrust bearing need to be added? I can't remember how the coilovers on my old S-chassis used to account for rotation. I'll see if can get pictures tomorrow.

I may just go ahead and machine the struts, then if I decide to go back and install camber plates it will be a lot easier than trying to fit them on the mill with the spindle welded on.

[White325is]

Sorry for the dead thread bump but as far as camber plates does anyone have an
inclination of if these COSMO plates for "COILOVER AFTER MARKET MOUNTS" would
work with the Air Lift 75563 strut?

COSMO for aftermarket

http://www.cosmoracing.com/productinfo.asp?cid=301&pid=2009

COSMO for factory strut
http://www.cosmoracing.com/productin...d=301&pid=2085

you need the airlift specific plates for the struts unless you make adapters to fit aftermarket.

[280zx2by2]

Sorry for the dead thread bump but as far as camber plates does anyone have an
inclination of if these COSMO plates for "COILOVER AFTER MARKET MOUNTS" would
work with the Air Lift 75563 strut?

COSMO for aftermarket

http://www.cosmoracing.com/productinfo.asp?cid=301&pid=2009

COSMO for factory strut

http://www.cosmoracing.com/productinfo.asp?cid=301&pid=2085

[Robs0nic]

So, I've recently bagged my bronzit E30. I've had an issue where it's not quite sitting all the way down in the front. Pic for reference, anyone else had this issue at all?


*Edit, after reading through this thread a bit, finding that just making small trims in the front should help quite a bit.
Uh duh.

[White325is]

Through the car or Under the car it is up to you.
I usually following the fuel/brake lines up front and run the passenger one across the subframe.

[z28]

Through where are you guys routing the air lines for the front bags?

[White325is]

That is the lowest in the rear you can go . I can price bolt in setup from airlift for you. No cutting necessary.

[Boris0bmx]

Is that at its lowest in the rear ? I dont like the idea of cutting of those "nipples"...cant it go that low without cutting?

Great build !

[Vanilla Gorilla]

Thanks for the tips Mike!

Clearly needs more low :D:D

[ForcedFirebird]

Thanks for the tips Mike!

[rasjgo1]

I pm'ed u ro

Sent from my SGH-T999L using Tapatalk

[rasjgo1]

I wany a install done too
White 325is
What's good

Sent from my SGH-T999L using Tapatalk

[dillon7]

Its 2500.00 for that setup.



Everyone in here is running the airlift rolling sleeve setup. By the time you purchase front shocks and bags you can buy the proper front setup.

ok sorry for the confusion, pm'ed you.

[White325is]

I also shaved and swapped this car.