m10 turbo + megasquirt first start

[zav3n]

a little teaser clip of what im working on..

http://www.youtube.com/watch?v=rLm2KDHFDUo

[fiftytakedowns]

at least explain your set-up

[kway]

Non intercooled?

[zav3n]

it a combo of junkyard volvo/saab parts and ebay turbo parts, and yes it has a water to air intercooler off ebay. im currently building a SLC-DIY wideband controller to hook up to the MS.

[Jaxx_]

Let me know how you like the SLC DIY. I'm getting ready to order one with the EGT sensor

[zav3n]

Let me know how you like the SLC DIY. I'm getting ready to order one with the EGT sensor

i got it in the mail yesterday, finished putting it together at work today seems easy enough to put together unless you a total pebkac you be fine. gunna go play with it today after work, ill tell you more once ii figure it all out ;-)

[Chabs]

did you make the downpipe or order it somewhere? I also have an M10 turbo with MS...

[Chabs]

ps - what did you do with your windshield washer fluid container? haha

[zav3n]

i just made my own downpipe ;-) and i have a IX windshield washer fluid container it sits were the battery was, i love the junkyard. Btw do you have msq i could build on im having real problems tuning the free rev range. email me @ zav3n@yahoo.com for a faster response.

[Jaxx_]

I have an msq for an m10 with a 292 cam. It's NA, but it could be worth looking at. let me know if you want it.

[SoopaGhetto]

it a combo of junkyard volvo/saab parts and ebay turbo parts, and yes it has a water to air intercooler off ebay. im currently building a SLC-DIY wideband controller to hook up to the MS.

i wish i knew about this wideband set up when i did megasquirt. seems sooo much better than innovate and comes with display.

[zav3n]

some more tuning and time to take it on the dirt ;-)

[Jaxx_]

bump...

I just finished setting up megasquirt and got it running, but I can't seem to get megasquirt to recognize the output of the DIY SLC. did you have any issues or are you running both separate? I'd like to have them in one datalog.

[SoopaGhetto]

does the unit output a 0-5v signal? did you change that config.ini (i believe) file to use wideband instead of narrow band?

[zav3n]

i know its a little late but here you go:

"MS will work with my product, interface is through the 0-5v linear output as with other units. You can either set things up in MS to work with my unit, or set things on my unit to work with MS, or mix and match. The default 0-5v output is 10-20 AFR which is the same as the PLX units, so you can select the PLX profile in MS. You change the range from default, and setup MS to work with the new range. In anycase it will work."