M42 piggyback install - Does this look right?
So to be able to tune fuel my piggyback needs:
Power - Ground - AFM In - AFM Out - RPM In
The E30 M42 Motronic pins that correspond to this seem to be:
Power = Pin 54 (Red/Wt) [Tap]
Ground = Pin 55 (Brn/Or) [Tap]
AFM In/Out = Pin 41 (Grey/Yel) [Cut]
RPM Signal = Pin 74 (Blk) [Tap]
Would someone please check my work? Does it look like this will do?
I know it looks like I am asking for a handhold and I'm not denying it.
This is my first foray into wiring in this car. Next is LC-1 install.
Power - Ground - AFM In - AFM Out - RPM In
The E30 M42 Motronic pins that correspond to this seem to be:
Power = Pin 54 (Red/Wt) [Tap]
Ground = Pin 55 (Brn/Or) [Tap]
AFM In/Out = Pin 41 (Grey/Yel) [Cut]
RPM Signal = Pin 74 (Blk) [Tap]
Would someone please check my work? Does it look like this will do?
I know it looks like I am asking for a handhold and I'm not denying it.
This is my first foray into wiring in this car. Next is LC-1 install.