Options for exhaust

[JA1991]

I had a 3in exhaust made for me by blueapplesoda and since i've put my coilovers on it scrapes on just about everything. Obviously Michigan doesn't have the best roads but i feel as if my exhaust hangs abnormally low. I like it a lot, it sounds good, i'm also going to be turboing my car over the winter so a 3in is what i'm looking for. What could i do to help my exhaust not scrape as bad without raising my car. It scrapes the worst in the rear around the axle portion. I don't really want to cut it apart but i'm thinking an oval pipe might be my only option??
I'm going to get pics tomorrow of how it sits.

[duleymane///iS]

That looks awesome, cant give you any advice on the tucking of it as i drive a 4x4 status e30, just wanted to know if you think its loud i have the same set up only i have 2.5 to 3in and that same muffler. Mine is really loud i dont like it.. GL with the scraping issue

[DetailAddict]

where is it scrapping?

[JA1991]

The Vband keep hitting the ground, but the exhaust is already sitting up as far as possible. So unless i weld it into one solid piece then i dont know

[Vivek]

Mounted pics would help. If it's already mounted up as high as it can go...that's about all you can do.

[JA1991]

i'll try to get some, where the vband about 1/3 of the way back is keeps getting broken, i haven't even lowered the front of my car yet, the back tucks tires, the front has like 2inches of wheel gap haha. i might make a smaller exhaust, but i plan on slapping a turbo onto it this winter so idk

[DetailAddict]

is it around the transmission mount? If I remember correctly, there isn't a lot of space there, but if you move it back a bit, where the cat/resonator used to be, you should have more space.

Leo