Announcement

Collapse
No announcement yet.

Anybody using this universal muffler?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Anybody using this universal muffler?


    Dual 3" tip 2.5" inlet muffler on Amazon. Would this fit in the exhaust cut out on an M Tech I apron?
    Last edited by Aviator; 07-06-2013, 12:49 PM.
    84 325e Burgundrot S52 M Tech 1.

    Your signature picture has been removed since it contained the Photobucket "upgrade your account" image.

    http://www.r3vlimited.com/board/showthread.php?t=250109

    #2
    I had something similar on my old M20B25 swapped Eta. I had a single 2.5" exhaust with a Cherry Bomb in the center, no cat, and one of these out back. It was the best sounding E30 I've ever owned.
    BimmerHeads
    Classic BMW Specialists
    Santa Clarita, CA

    www.BimmerHeads.com

    Comment


      #3
      Best sounding and cheap! I'm eventually going to throw in an M50, but a 2.5 pipe with a resonator or cherry bomb set up is what I have planned for my car.
      84 325e Burgundrot S52 M Tech 1.

      Your signature picture has been removed since it contained the Photobucket "upgrade your account" image.

      http://www.r3vlimited.com/board/showthread.php?t=250109

      Comment


        #4
        Well the jackasses sent me the wrong muffler. So while I'm waiting for it I scored a set of supersprint rep headers for my M50 swap. And a friend has a e36 m3 dinan rear section he'd sell me. Question I have will it fit the mtech 1 rear apron or not, if it will work on an e30 as well.
        84 325e Burgundrot S52 M Tech 1.

        Your signature picture has been removed since it contained the Photobucket "upgrade your account" image.

        http://www.r3vlimited.com/board/showthread.php?t=250109

        Comment

        Working...
        X