S50 Swap exhaust Clip, for those researching exhaust clips.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • TimKninja
    R3VLimited
    • Mar 2009
    • 2131

    #1

    S50 Swap exhaust Clip, for those researching exhaust clips.

    I know how hard it is to piece together the exhaust you want for your 24 Valve swap, i did Many hours of researching before I went ahead with this. General Opinions are,

    -Sounds Glorious in person
    -No Rasp
    -Alot of Drone except at 3000 RPM, which is 73 MPH (2.93, ZF Trans), which is where I cruise on my way to work, so it works out.
    -LOUD, Two mufflers doesnt mean its gonna be quiet. Mostly because their strait-Through Designs would be my guess. Ive only been pulled over once for it. But its loud. But its awesome as well.

    Dont plan on changing it anytime soon, I hung the center muffler too low so it scrapes everywhere. Dont do that. Might add something else like a cat to queit it down. maybe a bigger center muffler.


    Setup is

    Ebay long tube headers
    Connected to Flowmaster Y Pipe
    2.5 inch tubing
    Borla PROXS Mid muffler
    Vibrant streetpower Stealth at the rear


    Some youtubes for you guise. First one was right after i installed it,and drove it around. second time is after doing a tune-up, cold start



    1985 325e M50TU(Sold)
    1991 318is Slicktop (Sold)
    1990 325is Brilliantrot S50/5 Lug Swapped.
    1992 525i Manual shitbox Winter Beater
Working...