I need some advice on fitting my a single tip Stromung exhaust to my 318i (m42) m-technic rear valance. If you've seen this thread, you know that the Stromung's dual tips don't center in the mtech valance exhaust opening. It ends up looking like this:
IMG_9333 by Eric Berger, on Flickr
My fitment problem is even worse because the m42 Stromung only has one 89mm tip like this:
If I install it as intended (pointing straight out), it wouldn't be centered (too far toward the center of the car), and the tip would look too small for the valance opening that is meant for dual tips.
So I opted to buy mine without the exhaust tip welded on and try to figure out the best solution with the help of r3v ;D
I kind of want to keep it single tip and slanted toward the drivers side of the car like m42s are meant to be. It would look something like this
Thoughts?
Other options would involve using a generic Y-type exhaust tip , to make it look like a dual exhaust and fill out the valance opening more.
IMG_9333 by Eric Berger, on Flickr
My fitment problem is even worse because the m42 Stromung only has one 89mm tip like this:
If I install it as intended (pointing straight out), it wouldn't be centered (too far toward the center of the car), and the tip would look too small for the valance opening that is meant for dual tips.
So I opted to buy mine without the exhaust tip welded on and try to figure out the best solution with the help of r3v ;D
I kind of want to keep it single tip and slanted toward the drivers side of the car like m42s are meant to be. It would look something like this
Thoughts?
Other options would involve using a generic Y-type exhaust tip , to make it look like a dual exhaust and fill out the valance opening more.
Comment