DTM tips = Be gone!

[e30polak]

very clean eta overall, so props on that. as far as the tips, they look very close to those on the e36 m3. good factory look and as long as u like it, then that's what really matters.:D

[dinanm3atl]

Looks good :)

I will be going the Single N1 style rofl ;)

[So Live]

[dinanm3atl]

Thank you but all a magnaflow is is a fart can with a different case and two tips instead of one. No big deal :)

[JasonC]

They ain't rice. This shirt states what rice is.

[dinanm3atl]

They ain't rice. This shirt states what rice is.

Huge Muffler tip is rice? Is that the correct message?

[JasonC]

You know the civic's with the 1" exhaust pipe and a 5" tip.

[Jand3rson]

I really hope you aren't referring to my exhaust as rice.

[dinanm3atl]

I really hope you aren't referring to my exhaust as rice.

It was for me because I will be using a single outlet muffler

[MR 325]

I like fried rice.

[Mr Deagle]

so, is a full 3 inch stainless exhaust bad? even if its quiet?

[MR 325]

so, is a full 3 inch stainless exhaust bad? even if its quiet?

Full 3" is too big for a regular old NA M20.

[Rocla]

There's hoping everyone else likes them, and there's me liking them. I fall in the latter. :D


That's the idea. I'll do an engine swap when the motor dies, 24V. Until then, I'm putting a 323i intake manifold on this motor very soon, and either a 323i head (if I can find one), or building up the spare eta head I have into an i head.

M20b23 and m20b20 heads and manifolds are identical(at least on e30), but this might not help you since e30 320i's might be even harder to find than 323i's over there.

I have a spare manifold that I could give to you but the shipping would kill the idea.