headers

[slim_l2002]

right but will they hang low. that is my main concern right now. since my car is lower will they hang low like my shorty msds header do.

[z31maniac]

Don't bother with anything other than mid/long tube headers.

And on a stockish engine don't expect a big gain.

[slim_l2002]

what is the main attrraction for headers on the m20 engine? sound, performance, flow? and is it worth the money?

to me sound, performance and flow would be for any engine and m20. because they """"suppose"""" to flow better then stock. and if they suppose to flow better then stock then your performace in my eye should increase i dont know how much of an increase but it should go up and is it worth the money? it depends on how much they cost. getting headers no more then 350 form like ebay used or some shorty yes to me its worth the money. is it worth the money buying name brand long tubes that cost like 1K and up. then no cuz your not gettin that much performace from the headers. i belive you will get more out of it with an 325i or better or modded head then you would an E. my head will be changed in a few months with mods. but i did feel a diffrence wit my msds shorty headers but only a dyno will only prove that. and to me sound alot better. plus i only spent 200. used. i belive they are 275 new.

but that wsn't my main concren on my thread not to me a jerk or anything but i just need to know if these other headers hang to low. if anybody else is experiencing the same problem that i have.

[m30power]

what is the main attrraction for headers on the m20 engine? sound, performance, flow? and is it worth the money?

[slim_l2002]

Hello Revlimited. im looking for get another set of headers. right now im useing MSDS shorty headers. but the downpipe on them hangs too low and my car is slammed. it hangs too low to the point where every speed bump i go over no matter how or what angle i go into it. its drags. and the results to that... well its broke the flange to the header. I dont know if its wroth gettin its welded back in place and rerouting the down pipes or what. and i was looking at ebay headers and i found a few longtubes. and im tryin to see if anybody had any problems with it being low. or fittmet issues.

http://cgi.ebay.com/ebaymotors/Parts...3A1|240%3A1318

have any body have these?

http://cgi.ebay.com/ebaymotors/Parts...3A1|240%3A1318

and these look like that would hang low and drag but i don't know.

also the IE shorty headers do they hang low as well?

i can take pictures to show how low they hang if anybody needs them.