what turbo for m20b25?

[einstein57]

I think a gt35 is a bit overkill for 12lbs. Maybe a gt30

[e30leigh]

Full boost comes on 3200rpm

thats not too bad. is there anything else done to the motor other than the turbo hanging off the side of it?

[sayed ali]

Full boost comes on 3200rpm

[e30leigh]

my thoughts were to go with a gt35 .63a/r turbine and about a .70a/r compressor.

This is the one that I'm running now

It would be great idea for your setup

I'm boosting it over 1 bar and it pulls perfect

when does the boost come in man?

[e30leigh]

For 12 psi you can use a blow dryer.

i tried. but the inverters kept dying. and i couldnt find and extension cord long enough to get me from home to work.

and other than that. have you every tired dealing with a missus after shes gone to do her hair after shes had to remove her hair drier from under the bonnet of a car? its like trying to tell a hungry pitbull that he doesnt accually need that nice cow bone.

[einstein57]

For 12 psi you can use a blow dryer.

[ak-]

my thoughts were to go with a gt35 .63a/r turbine and about a .70a/r compressor.

This is the one that I'm running now

It would be great idea for your setup

I'm boosting it over 1 bar and it pulls perfect

Inte majnoon Ali.

[Hey_You]

I'm not sure why you would want to run a 4.10 diff with a turbo engine on a m20. Besides, everyone here runs a Holset nowdays!

[sayed ali]

my thoughts were to go with a gt35 .63a/r turbine and about a .70a/r compressor.

This is the one that I'm running now

It would be great idea for your setup

I'm boosting it over 1 bar and it pulls perfect

[e30leigh]

hi there guys.

i was looking into turbos the other day.

and it dawned on me i wasnt sure what turbo i should run.

i want to stay away from the common t3t4 to4e that people here run on everything.

my thoughts were to go with a gt35 .63a/r turbine and about a .70a/r compressor.

the other option was a td06 20g t3 flanged.

the motor will be m20b25, mls hg, arp stud kit, balanced internals, lighten flywheel, spec stage 3 clutch, mild cam, turbo adapter, fmic, 2.5" cooler piping, 3" exhuast, 38mm gate, boost kept to 12psi max, getrag260, 4.1 diff eventually, and not sure yet if ill go blow through miller maf or standalone with map.

im not all that familiar with some of the turbo part numbers you seem to use.

im familiar with the garret type range. t25, gt2871rs gt30, gtx3078rs, gt35, ect ect
also familiar with the td0 range. td04h, td05 8g,16g,20g,22g td06 16g,20g ect ect ect.

if you could compair anything to those that would be great. it works easier in my head to compair it to what i know.

thanks, leigh