What hotside housing should I buy?

[ser1992]

I have an hx35 12cm and a full Revshift manifold (non splitpuls). should i look for a non gated non splitpuls housing? if so who makes it and where can i buy it.

Im looking to make somewhere around 400hp when finished, is a 12 cm enough or should i look for a 14?

[E30-323ti]

IIRC you can get an 'O' or 'N' trim T4 turbine housing ported to suit the HX35 turbine.

Otherwise, I think Bullseye Power (BEP) are the only ones that do an off the shelf T.Hsg, but are a bit smaller (~8cm) as they were developed for the DSM crowd and come is a variety of inlet & outlet configs.

[Pootis]

12cm will be enough to make 400hp 14 will just be more lag I would stick with the 12

[kamotors]

10cm makes 400hp just fine.