Hello guys, I am from New Zealand, I am needing some help with the bracket design to mount a toyota blower to a M50/M52 BMW engine.
I have seen a few brackets done where the charger sits in the cold side of the engine, in place of the air box, but all the brackets had only the two bolts near the vanos holding it in? Could anybody give me some advice, any measurements if its been done before or somewhere I could start. i am absolutely no good with fab work but was thinking to tinker with it, maybe have someone make me the brackets but I need to know what would be the ideal design.
cheers
I have seen a few brackets done where the charger sits in the cold side of the engine, in place of the air box, but all the brackets had only the two bolts near the vanos holding it in? Could anybody give me some advice, any measurements if its been done before or somewhere I could start. i am absolutely no good with fab work but was thinking to tinker with it, maybe have someone make me the brackets but I need to know what would be the ideal design.
cheers
Comment