anyone care to help me i.d this turbo? I was told its a holset h1c turbine mounted to an hx60 compressor. Im fairly certain based on research that this is correct, I did notice though that there is no pressure nipple on the compressor, its on the wastegate?
-
-
Hello, Looks like a HX35/WH1C turbine housing (probably 12cm2), WH1C/H1C center section, no way of telling on the compressor wheel size without measurements or pictures. Doubt that is a a HX60, maybe a 60mm wheel however. Hope this helps. -
Any reason there's no nipple on compressor housing?Comment
-
The OE application did not call for it. If I was guessing, this is a turbo assembled from at least two units, the original turbo that the compressor housing came from more than likely did not have a wastegate actuator.Comment
Comment