So.. New crank sensor.. no start <wtf official forum>?

[E30QC]

Hey buhuhddies (a la poly shore)
I had a bad sensor for my engine position (cranksensor) so I swaped in a new one, the problem was my connector too was f'd on the cpu side, so I spliced a new connector in (male and female) now that has come apart..
I would like to know If i resplice it and soter it (if that is indeed How one would spell sodder) would that screw with the signal to the ecu?
tanx a mill for the answer
mike
p.s. anyone heard of a complete wiring kit for an e30 before, I'm swappung my electricals into a 318is body, but shes' a 325es right now... just checking

[vr2jetta]

(if that is indeed How one would spell sodder)

Solder. Sorry I cant help with anything else.

[whiltebeitel]

You can buy a complete stock harness if you want. Soldering won't mess with the ECU, it's heat, not a current. You'll be fine.

[E30QC]

i meant signal wise, thanks

[E30QC]

guys your the bomb, soldered it, see above, and she fired under a good jump start, my battery is shot, also, she backfires when rev.d hard, and stalls under heavy foot action>
\ideas, anyone? bueller? bueller>?