2.5 piston cut-away

[rvaughnp]

went ahead and cut one of the pistons i have.
measured in inches. measured at .29" converts to 7.37mm thickness.
Still doesn't mean much until i send them out and they get checked out for the possibility of shaving.

Thought it would be cool to have a cut away pic around.
Sorry, couldn't short pic size.

rvaughnp

[!kid]

why not just use a micrometer to get the messurement?

[Aptyp]

If you want, tomorrow I'll cut you an E piston :)

[rvaughnp]

why not just use a micrometer to get the messurement?

I did measure it for myself. This was put up to help others that may have this question and or don't have a micrometer. But more importantly, any future questions on this will have a factual picture for viewers to see rather than just someone writing what they know.

rvaughnp