Where the hell do i wire in the C101 on my eta engine??
I know what all the wires are, but im wondering if i have to put power to certain wires? if so, which ones?
A picture i saw had descriptions it was:
pin 1 = D+ = alternator charge indictor
pin 2 = sta = oil level - static
pin 4 = ft = coolant temp guage
pin 5 = ol = oil pressure
pin 6 = 15s = voltage with ignition turned on (fuse protected)
pin 7 = 15u = [same as above, but non fuse protected]
pin 10 = dyn = oil level - dynamic
pin 11 = SI = service indicator reset
pin 13 = EP = electric fuel pump
pin 16 = A = air bag
pin 18 = 50 = voltage while starting.
P/s this car is stripped of everything.
I know what all the wires are, but im wondering if i have to put power to certain wires? if so, which ones?
A picture i saw had descriptions it was:
pin 1 = D+ = alternator charge indictor
pin 2 = sta = oil level - static
pin 4 = ft = coolant temp guage
pin 5 = ol = oil pressure
pin 6 = 15s = voltage with ignition turned on (fuse protected)
pin 7 = 15u = [same as above, but non fuse protected]
pin 10 = dyn = oil level - dynamic
pin 11 = SI = service indicator reset
pin 13 = EP = electric fuel pump
pin 16 = A = air bag
pin 18 = 50 = voltage while starting.
P/s this car is stripped of everything.