If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
Unichip and HFM installed and tuned, dyno results.
I have asked several sources and read the Bosch shop manual but I could not confirm this. It makes sense Bosch would do this, but I could not find it in writing. I was planning to just splice in a 2.5K ohm resistor.
My info comes from Bexleys workshop in UK.....reliable....dunno.....but they've been doing MAF conversions w/ the Unichip piggyback unit for at least a couple of years. 3 of us are running MAF's with our strokers out here and no temp sensor and no problems so it seems Bexleys was correct.
Obviously the temp sensor should be connected and as soon as I get un-busy it will be done...... :)
Comment