I am thinking about putting this motor together:
I Pistons, M52 (84mm) crank, ETA rods, 885 head shaved ~0.5mm = CR ~9.5:1
.... and I am wondering if anyone has first hand knowledge of an aftermarket cam or cam profiles that will work with this set up?
I know I will need to mock it up either way. I have built many motors, some professionally and know the drill. But I figure someone has already been through this before and might already know.
Also, sort of a side note/question... Has anyone run a hotter than stock cam and left the stock valve springs in? Horror or success stories?
I Pistons, M52 (84mm) crank, ETA rods, 885 head shaved ~0.5mm = CR ~9.5:1
.... and I am wondering if anyone has first hand knowledge of an aftermarket cam or cam profiles that will work with this set up?
I know I will need to mock it up either way. I have built many motors, some professionally and know the drill. But I figure someone has already been through this before and might already know.
Also, sort of a side note/question... Has anyone run a hotter than stock cam and left the stock valve springs in? Horror or success stories?