Custom engine mounts too short, problem?

[akorcovelos]

I'm getting some custom UMHW engine mounts, and an aluminum trans mount made for me, had a couple questions.

If the engine mounts are .138, just over 1/8th inch undersized will that cause too much binding in my drive line? Cause premature flex disc wear? The trans mount is aluminum and made to AKG dimensions.

[nrubenstein]

No. And you could always make up the delta with a couple big washers.

[akorcovelos]

Thats what I was thinking, though if it won't cause any binding or excessive wear why not take the lower COG?

[scottinAZ]

unless you are really lucky, your factory mounts have sagged more than 1/8 inch. You should have no issues with the new ones