If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
make it so it will fit in the stock location or supply hard lines to make it fit with the stock hoses.
unless it solves a problem with the stock one and it's location, relocating it will hinder your sales.
it just becomes engine bling at that point. (i realize you are increasing the volume of the res. and there by increasing thermal reserve to an extent.)
also if it requires any additional fab beyond what you supply, it will not sell as well. people are lazy that way. if it is not handed to them, they are reluctant to buy.
just my experience
seien Sie größer, als Sie erscheinen
Your signature picture has been removed since it contained the Photobucket "upgrade your account" image.
make it so it will fit in the stock location or supply hard lines to make it fit with the stock hoses.
unless it solves a problem with the stock one and it's location, relocating it will hinder your sales.
it just becomes engine bling at that point. (i realize you are increasing the volume of the res. and there by increasing thermal reserve to an extent.)
also if it requires any additional fab beyond what you supply, it will not sell as well. people are lazy that way. if it is not handed to them, they are reluctant to buy.
just my experience
It is better over stock as it is at a higher point and increases capacity by a great deal.
Any additional fab will be included (Trust me, the E9X guys are even worse when it comes to literally EVERYTHING included in our kits of products for those cars)
Comment