engine pull help

[Chaz]

Trying to remove an engine from my 87 chassis. It is an auto. The Bently manual says nothing about revoming the tranny or disconecting the driveshaft. Right now I need to know the size of the oil cooler bolts because I can't get them out. My 22mm isn't big enough.
Ideas.

[89 e30]

You can count right? If 22 isn't big enough you try a 23 than 24....

[Mikey J]

I have a 90 325is that I just finished pulling and my oil cooler lines had a 27 mm nut on them. I seperated the manual tranny prior to pulling but installed it back with both together.

[ak-]

You can count right? If 22 isn't big enough you try a 23 than 24....

I dunno man, that's kind of hard.

[Chruby99]

Pull it out together

[5Toes]

Ever heard of a monkey wrench?? Worked fine for me

[Chaz]

Yea, well was just stuck. PB blasted it.
Did you pull the engine out from beneath the car chruby?

[MR 325]

^ Considering the car is right above the engine with no subframe, I'd say yes he did.

[cheapshot]

Yea, well was just stuck. PB blasted it.
Did you pull the engine out from beneath the car chruby?

Easiest way to do it.

[Chruby99]

Bought a pallet jack, a pallet, and an extra set of jack stands. Took me about half a day by myself. I am sure it could be done faster. But I took my time.