Is a 800/900 rpm idle a problem

[the_ps]

yea imma try those out..did you j-bweld the gaps or is there a way to replace them. I already know theyre a little lose but i figured if they were in they were good

I used red loctite on the shaft and non-hardening gasketmaker on the flange. I think most people use JB Weld. It is probably better, but I was feeling lazy. I can't wiggle the elbow any more and my idle is absolutely 100% perfect.

[ROLLingKING]

I used red loctite on the shaft and non-hardening gasketmaker on the flange. I think most people use JB Weld. It is probably better, but I was feeling lazy. I can't wiggle the elbow any more and my idle is absolutely 100% perfect.

thanks..ill try this after my oil pan is done, tmrw!!

[ROLLingKING]

this should be a sticky

solved

http://www.pelicanparts.com/bmw/tech...leshooting.htm