Can I reuse intake gaskets?

[txbeemertx]

89 325is changed injectors... Can I reuse intake gaskets?
Thanks

[Bimmerguy91]

I wouldnt. Unless it was brand new. But even still probably not

[txbeemertx]

I wouldnt. Unless it was brand new. But even still probably not

Ok I was thinking the same but wasn't 100% sure since they looked like well built gaskets. Ok thanks!

[Bimmerguy91]

No problem.

[future rs]

It's not recommended. I have in a tight spot but you have a higher chance of leaks.

[TG Goose]

I had my intake all nice and tight with fresh gaskets on the engine stand. decided to remove intake for motor install and re-used the gaskets. done a smoke test and they dont leak. probaby only because they were only torqued for a week, but it worked out for me.

[mbonanni]

I used gasket paper to make one. Doesn't leak :)

[5Toes]

put rightstuff or threebond on it and good youre good to go

[jaywood]

I would replace them, they are cheap. Waiting for them in the mail is annoying though :(

Did you only replace the injectors? If so, you don't have to pull the intake mani. You just have to maneuver the fuel rail around a few things! If not, please disregard this ;)