If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi Jim I tried contacting them is it possible they do not have over sized pistons for the M20 B25 say 86 mm The fellow I spoke with told me they only offer 84.5 which is basically stock. I also like their brand just having problems finding them
Thanks
OK i finally spoke with someone at MAXSIL and they have what I need
I dont know what your price range is, but I picked up a set of CPs from VAC. A bit expensive, but worth it imo.
85mm would probably be your best bet. From what I can tell by measuring the block 86mm may be pushing it. However I dont have any solid info to back up that last statement.
Hey Chris thanks for the introduction I called them up and talked with Steve very knowledgeable told him what I wanted and he's going to send everything with prices.
Comment