Announcement

Collapse
No announcement yet.

ha another e to I swap problem????

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    ha another e to I swap problem????

    Well im stumped with this one but I had recently finished swapping a 89 m20b25 into my e and she starts right up but last night while she was idling I was trying to figure out my fuel problem Couse when I give her some throttle she bogs down and almost dies but anyways I unplugged my cps while she was idling and the engine immediately shut off so I plugged it back in and went to crank her back on and now she won't start she cranks but doesn't turn all the way over I've never heard of this happening any to help me out please?

    #2
    Have you tried replacing your cps?
    M30 is God's motor.....but Jesus drives an M60'd car -slammin.e28

    Comment


      #3
      no not yet that was my next guess but it doesn't make since that just by unplugging it while the car was running that it would cause it to go out on me unless I fried some thing?

      Comment


        #4
        Actually that can (and does) happen. The sensor lead wire, if original, is pretty hard and brittle now. So moving it can cause an insulation failure.
        The car makes it possible, but the driver makes it happen.
        Jim Levie, Huntsville, AL

        Comment


          #5
          Nvm I got her to start again thanks for the info

          Comment

          Working...
          X