Hi..first post here. I recently installed an 86 m20/ getrag 260 into my 86 325es. It fires up, but quits within 10 seconds. If I try and start it immediately it'll run for 2 seconds....if I wait a minute it'll start and run for 10 seconds again...but that's it. Help :)
ummm figure I should add some more info here.. well I pulled the car into garage few weeks ago and it ran fine..well except the bagged clutch..lol,,and 400,000 mile engine..lol...but I digress. the fuel system seemed fine 3 weeks ago...but now i'm reading 90 psi fuel pressure at the fuel rail which I believe is far too much ???...have blown out feed line..return line and the vent line looking for a restriction, but no change ..the tank is 3/4 full...., check engine light comes on and stays on. can't think of anything else too add right now..survivor just came on and all the girls in water panties have me distracted..haha
ummm figure I should add some more info here.. well I pulled the car into garage few weeks ago and it ran fine..well except the bagged clutch..lol,,and 400,000 mile engine..lol...but I digress. the fuel system seemed fine 3 weeks ago...but now i'm reading 90 psi fuel pressure at the fuel rail which I believe is far too much ???...have blown out feed line..return line and the vent line looking for a restriction, but no change ..the tank is 3/4 full...., check engine light comes on and stays on. can't think of anything else too add right now..survivor just came on and all the girls in water panties have me distracted..haha