After swapping chassis' the m20 has been giving me some problems. At first it bogged down around 4k at WOT, but after driving around for a bit i can barely give it 1/2 throttle before it bogs and loses power to the point where it will stall. I also noticed i had a huge coolant leak and once i plugged that up it drove much better, just bogs at WOT again. Could this be caused by improper coolant bleeding? I have been struggling to get the last bit of air out.
-
-
Check your plugs?
I had really bad jerking, bogging whenever I went near wot. Changed the plugs drove it hard a few times and went away. Test the TPS as well.
-
Afm might cause power lossComment
-
If it runs fine at high RPM at 3/4 throttle, but not at WOT, it might be your TPS as 3vilE30 stated.90 325i DD/Track
03 Durango 5.9
Originally posted by e30mpgComment
Comment