If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
M20 in a 89 E30 (325i) is it possible to replace the cam without pulling the head? The cam shaft broke between the #6 intake and exhaust lobes and I'm wondering if I remove the radiator, etc. if I can get the cam out the front?
M20 in a 89 E30 (325i) is it possible to replace the cam without pulling the head? The cam shaft broke between the #6 intake and exhaust lobes and I'm wondering if I remove the radiator, etc. if I can get the cam out the front?
Rob.
The only way to do that would be to remove the front radiator support from the car..IE cut it out and weld it back in.
You can pull the cam all the way out if the radiator and ac condensor are out of the way. I pulled mine halfway but it would not interfere with the core support. If it were a problem, the motor would only need to tilt forward slightly. I believe the intake side rocker shaft is the only thing that will hit the core support.
Comment